Here's the drivers windows is still using when I connect the board. Under Unspecified, USB Blaster should be listed. Open the Device and Printers (Control Panel Devices and Printers).
How about should I try removing the drivers windows wants from the folder they're in? Thanks for your support. To install the driver for your USB Blaster cable, follow the instruction for your particular operating system. Should I try 'disabling' the driver rather than 'uninstall' them? UPDATE: (fail) OK, so the auto-install pop-up did not show, as expected with auto-install turned off, however, once I disconnected the board, and then reconnected the board a minute later, the same problem drivers (serial converter and (COM4)) showed up again - but now when I disconnect the board, these drivers disappear from the devices window. Normally, when first connecting a board, Win10 tries to find 'suitable drivers' for new hardware, and you abort that process and point to the drivers manually.īut I am assuming I can leave 'automatic download of apps' off while I complete the installation, and then turn back on for good measure, once the board is confirmed to be on-line - is this correct? Thanks. Tutorial de como Instalar los Drivers del USB Blaster para Quartus II desde la computadoraCanción de fondo 'what if city' by Sad Mélomano. I then uninstalled the problem driver from the USB devices, and restarted the PC - the driver is still gone. I have right clicked in file explorer on 'This PC', select 'properties', then 'advanced system settings', select 'hardware' tab, select 'device installation settings', select 'no' to 'do you want to automatically download manufacturers' apps. Ok, I am going to try something, as soon as I am convinced it is safe to try. Is this a situation where I have to go into safe mode (or something) to remove a deeper driver remnant? Thanks for your support. The driver is showing that it is 'not migrated' and in the other panel it is 'working properly' - the device show in the detains in the attached image.
Still, I am unable to raise the 'new hardware found' as expected after a re-install - there must be remnents I need to remove.? When I in-installed the driver in this window, Win10 did not allow me to find drivers after connecting the board with Blaster ii (Terasic Max2 NEEK) - it simply re-installed the drivers it chose for me the first time. It keeps coming back when I remove it or remove/re-install Quartus.
So it shows up as a USB device 'VID_XXX' composite' - it's the last entry 'USB Serial Converter' in the attached image. If you are prompted to answer a question about Windows XP Update, choose No, not this time and click Next. They are provided with the Quartus II installation files and you will need install. Plug the USB-Blaster or USB-Blaster II download cable into the PC. There is no separate download for the USB Blaster drivers for Windows 7.
I have not been able to get the PC to install the correct drivers yet, so the Device manager shows a generic driver of some sort that Windows10 picked. Driver Installation for Quartus II Software Versions 6.1 to 7.2.
Thanks to our community members who provide support during our down time or before we get to your questions. # Intel FPGA Download Cable hotplug script USB Blaster driver installation for Quartus 19.1/20.1 - Intel Communities Intel Quartus Prime Software Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Create a file named /etc/hotplug/usb/usbblaster and add the following lines to it.Add the following lines to the /etc/hotplug/usb.usermap file.Driver Setup on RedHat Linux Enterprise 4 and Below